All of the trays are currently set as default, but I have tried setting the Envelop Feeder and Tray 1 for Envelope #10, Tray 2 as Letter, and I got the same response. īut i've just tried it again, and it's now clear! If you open the attached image in a new tab it opens full screen, and isn't blurry. I even removed the Feeder and use the Tray 1 Manual Feed tray and received the same prompt result. I don't know what would enable the printer to start asking for us to manually feed something when the Envelope Feeder is there and full. We have also went through tab by tab to see if there were any setting changes between the two drivers, and there were none.

We have rebooted the computer, printer, and print server with no change. I need to get this resolved so that I can shut down the old server. Since we still have the 2008 server in production, I have reverted this department back to that server and everything is working fine. I also updated the firmware on the printer to the most current version.

I rolled the drier back on the 2016 server to the same driver on the 2008 server, and we still had the same issue. This was not the case when the printer was on the 2008 server. As soon as we press OK it prints from the Envelope Feeder. As soon as we tried to print envelopes to the installed Envelope Feeder, we get a prompt each time on the printer asking us to Manually Load Tray 1, or press OK. When I moved it to the new server I updated the driver from the 'HP Universal Printer PCL 6' driver to the downloaded 'HP LaserJet M604 PCL 6' driver. So far all of our printers have been fine, however this one is giving us issues and I'm not sure what else to try. In doing so we have migrated all of our printers over to a new 2016 server. We had this LaserJet M604 on a 2008 print server that we are phasing out of service.

Canon mp600 manual feed